Local device, service transmission will be interrupted.Ĭreated and the IPSec proposal view is displayed. Of the IPSec tunnel is a Cisco device, you need to configure thisĬommand on the local device.
Protocol uses the SHA-2 algorithm and the device at the remote end The device differs from that on a Cisco device. The device is configured to use the same SHA-2Įncapsulation/decapsulation mode as that on a Cisco device.īy default, the SHA-2 encapsulation/decapsulation mode on Ipsec authentication sha2 compatible enable A matched permit clause indicates that a dataįlow needs to be protected and a pair of SAs is created.īy IPSec is decrypted and the packet not protected by IPSec is forwarded. Matches a deny clause or does not match a permit clause, IPSec directlyįorwards the packet. A packet is processed according to theĪ permit clause, IPSec encapsulates and sends the packet. In IPSec applications,Ī permit clause identifies a data flow protected by IPSec, and a denyĬlause identifies a data flow that is not protected by IPSec. To define data flows to be protected and apply the ACL to an IPSecĮach ACL rule is a deny or permit clause. In practice, you need to configure an ACL Used to establish an IPSec tunnel, the ACL can specify data flows
Thanks for reading.IPSec can protect one or more data flows.
I thought it might be something to do with the format of the csv file so I ran the dos2unix command but got the same error message. Mgmt_cli -s id.txt add access-rule "MY_POLICY_NAME Network" position.bottom "my section name" source "host_object" destination "group_object" service.1 "TCP111" service.2 "TCP222" service.3 "TCP333" action "Accept" track "Log" comments "my comments" If I run the command manually below it works fine and adds the rule MY_POLICY_NAME Network,host_object,group_object,TCP111,TCP222,TCP333,Accept,Log, Layer,position.bottom,source,destination,service.1,service.2,service.3,action,track,comments This is the contents of filename.csv (other rules omitted for brevity reasons) Line 2: code: "generic_err_invalid_parameter_name" Mgmt_cli login -r true -d -batch filename.csv This is being run on an MDS server hence the -d option I'm getting an error message when trying to create multiple access control rules using mgmt_cli and referencing a csv file.
0 kommentar(er)
